Roofing isn’t a particularly easy job, but there are a few tips and tricks that can help you get the job done quickly and efficiently. First of all, avoid heights! You should be fit and not afraid of falling. You should also try to practice by going up and down a ladder a few times. Make sure that you have two long ladder straps and a chest buckle. Lastly, use a three-point harness that secures you most of the way up and down the roof.
Before starting a roofing job, measure all the roof planes. Include any additions or dormers. Multiply each plane by 100 to get the total squares of the roof. Make sure you buy extra shingles to avoid having to start over later. If your roof is steep, you may need to buy more than one piece of roofing material. The first time you apply a new layer of shingles, make sure that you practice on a smaller area first.
While the job of reroofing may not require a lot of tools, it should still be done correctly. Before you start, mark a specific spot on the roof using a utility knife. If you don’t know where to start, use a chalk line to mark your location. Next, you need to ensure that the shingles are laid in a staggered pattern. Remember to measure the shingles’ reveals so that they are not touching each other.
When applying shingles, make sure to install them in a way that the prevailing wind blows over the overlaps. If the roof is flat, the shingles will stick together better. If not, they’ll tend to fall off because the adhesive strips are too warm. During warm temperatures, the ice-and-water underlayment will lose its seal and become too soft. If you are using a roof that’s already installed, you can still use it successfully.
Once you’ve made a ridge cap, you can install the top ridge cap on either side, or in the center. The shingles should be overlapping in order to allow for the prevailing wind to pass over the overlaps. Afterwards, nailed the final shingle on both sides. If you are using a self-stick underlayment, make sure that it is adjustable.
Always wear a hard hat and stay in the safety zone. You can fall and damage your roof. To prevent falling, wear a safety helmet. During the installation process, be careful not to drop anything. It’s possible that you’ll fall. But if you’re careful, you’ll be able to avoid that. If you don’t like heights, try to install a small one.
